FJC 9165: Kwik Seal Stop Leak Aerosol Can w/Charging Hose

Product ID: 9165
Manufacturer: FJC
Price: $22.90

Browse more in Leak Stop Products category

Description

As seen on Speed Channel's "Two Guys Garage" Show

**Product cannot ship with Expedited Shipping- must ship Ground**

FJC 9165 Kwik Seal Stop Leak- Aerosol Can with a Charging Hose!
- Advanced formula STOPS LEAKS where others fail! Stops Leaks in condensers, Evaporators, Hose Connections, Gaskets and O'Rings
- Perfect for the Do-It-Yourself mechanic
- If your refrigerant leaks down in about 4-5 days then this product will work for you!
- Seals most leaks in all metal and rubber components
- No Stop Leak product will seal a compressor shaft seal leak
- Kwik Seal Stop Leak creates a permanent seal
- For use in R134a systems only
- Kwik Seal Stop Leak will not damage A/C Recovery/Recycle Equipment
- Add Kwik Seal Stop Leak to any R134a automotive system to prevent leaks
**Includes an easy-to-use hose with R134a quick coupler- No other tools are needed**
Easy to Install Kwik Seal Stop Leak

- Step 1: System must be fully charged with refrigerant prior to using this product. Locate A/C low side R134a service port, remove cap and push yellow hose connector on to the fitting
- Step 2: PushLok™ fitting locks on to service port allowing easy, hands free installation of Kwik Seal Stop Leak
- Step 3: Start vehicle engine and set A/C controls to MAX COOL
- Step 4: Depress the push button on the can to allow entire contents to enter the A/C system. Remove Kwik Seal Stop Leak connector and replace the service port cap. Allow your vehicle to run for a minimum of 15 minutes with the A/C on.

Also available in a case of 6. See FJC 9165-6
Need a Stop Leak for an R12 system? See FJC 9160

Testimonials
2/17/09:

During a recent hot spell I discovered my 1999 Chevy Malibu was blowing warm air. I tried to recharge the A/C system but the high pressure side would not go above 70 PSI indicating there was probably a leak somewhere. Kwik Seal is a trusted name in stop leak products so I purchased a can of FJC 9165 Kwik Seal Stop Leak and installed it in the A/C system following the instructions on the can. I was then able to recharge the system with R134a until the high pressure side read 150 PSI. The A/C in my car now blows cold air just like it's supposed to.

I purchased the FJC 9165 Kwik Seal Stop Leak primarily because it stated it was safe for A/C recovery and recycle equipment. This product was very easy to use since it came with a charging tube, it performed as advertised, and probably saved me over $1,500! This is a great product and I would definitely recommend it to my friends. R.S.

**Note: Expedited Shipping not available for this product- it must ship via Ground**

**Canada- due to the product being packaged in an aerosol can, it cannot be shipped to Canada due to USPS Air Regulations.**